|
|
|
10-30-2002, 10:28 PM
|
#1 |
|
Registered User
 Join Date: Jul 2000
Location: Hampton, Ga, USA
Posts: 217
|
Flexplate Bolts
I am installing a flexplate on new engine using ARP bolts. I notice there is a slight amount of clearance between the holes and bolts and you can rotate the flex plate a fraction of an inch back and forth with the bolts only finger tight. Is this clearance normal?
__________________
68 Short Stepside, 350, quadrajet, 700r4, 3:73 posi, power front discs, HEI, Factory Air, Tilt, Tach, accelerator cable instead of rod, sway bar. 96 Impala SS 97 Monte Carlo |
|
|
|
10-30-2002, 11:08 PM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
yes, this is normal as the holes in the flexplate are slightly larger than the bolts
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
