|
11-12-2002, 08:34 PM | #1 |
Registered User
Join Date: Oct 2002
Location: Oregon
Posts: 69
|
Frame chopping?
I am going to cut a 72 long bed 4x4 frame to short bed specs. Anyone have any details as far as how to go about it? I am a capable welder and have a good mig and plasma cutter to work with. Would also like to know the exact amount on how much I need to shorten the frame between the front and rear axles. Also what about the rear of the frame? Thanks for any info you share.
|
11-12-2002, 08:40 PM | #2 |
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
12" out of the middle, & 8" off the butt.....
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
11-12-2002, 09:12 PM | #3 |
aka Crusher, Crushergmc
Join Date: Mar 2000
Location: Oregon
Posts: 1,834
|
PM efabman, He did this to a 2wd and did really nice work. The "z" in the frame was right as rain. Good luck.
__________________
"KEEP IT DOWN!" 70 Jimmy 454 2wd 56 GMC Big Window "It's funny till someone gets hurt, then it's freakin' hilarious" |
11-12-2002, 09:36 PM | #4 |
Registered User
Join Date: Oct 2002
Location: Oregon
Posts: 69
|
Yea, I should have done a search first before posting this. I looked at his work and it was first rate. Thanks!
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|