|
|
|
08-28-2008, 02:07 AM
|
#1 |
|
I had a V-8
Join Date: May 2003
Location: Phoenix AZ
Posts: 1,116
|
Oil Pressure Gauge Q
I have a good oil pressure gauge for my '72 Sub that says 60lbs on it. Did they make a higher pressure rated gauge?? I have a feeling that my Cummins is going to make more than 60lbs of oil pressure. I know in the 73+ they had 80lb units, but I don't know if they made them earlier. If not, has anyone run into problems running their oil pressure gauge pegged for extended periods of time??
__________________
1972 K20 Suburban, 5.9L Cummins, Banks Power Pack, NV4500HD, NP205, H.A.D., D60/14FF ARB Link To Build: HERE. |
|
|
|
08-28-2008, 05:39 AM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Re: Oil Pressure Gauge Q
if you were to get a guage out of a 67 - 72 C/40 and bigger... they are 80 psi.
|
|
|
|
|
08-28-2008, 12:13 PM
|
#3 |
|
72 GMC
Join Date: Feb 2008
Location: Wells, Maine
Posts: 534
|
Re: Oil Pressure Gauge Q
|
|
|
|
|
08-28-2008, 12:19 PM
|
#4 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Re: Oil Pressure Gauge Q
if you need an air pressure guage, then sweet! (i dunno what you'd hook it to though)
Heck, if it goes cheap enough, then you could just swap out the oil guage on that panel, then sell the whole thing on e-bay again! |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
