![]() |
|
![]() |
#1 |
Registered User
Join Date: May 2002
Location: lexington,South Carolina
Posts: 158
|
![]()
Does anyone know where I can get my factory tach calibrated. It reads correct at idle but after that it is about 1000rpm over actual rpm. I have installed a HEI dist. would that be affecting it?
------------------ 69-C10 LWB
__________________
69-C10 LWB 71- fleetside shortbed It's a shame stupidity isn't painful Never play leapfrog with a unicorn |
![]() |
![]() |
![]() |
#2 |
Binder Rep
Join Date: Jan 2001
Location: Salcha, AK
Posts: 1,506
|
![]()
did the tach come from a 6 cyl truck?
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: May 2002
Location: lexington,South Carolina
Posts: 158
|
![]()
I don't know I bought the whole instrument pannel at a swap meet. If it is can it be recalibrated?
------------------ 69-C10 LWB
__________________
69-C10 LWB 71- fleetside shortbed It's a shame stupidity isn't painful Never play leapfrog with a unicorn |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Dec 1999
Location: Old Mission, MI, USA
Posts: 2,510
|
![]()
These tachs are notoriously inaccurate. There is a screw on the back where you can adjust it. HEI will have some effect, but most of them are not accurate with points either.
------------------ Tim
__________________
Tim |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Dec 2000
Location: Indiana
Posts: 3,074
|
![]()
You can calibrate any factory tach, 6 or 8 cylinder tach with the calibration screw on the back of the tach. You will need another tach to compare to when you adjusting it.
I recalibrated my factory 6cyl tach against an aftermarket tach, on my 71 with HEI & V8. Works perfect. ------------------
__________________
71 Chevy CST Long Fleet 350/350/3.07 leaf rear. |
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: Aug 2001
Location: escondido, ca 92026
Posts: 1,222
|
![]()
this is the tach adjustment screw....
![]() ------------------ '72 short step, 350, 700R4, tilt, ps, pdb, a/c, lowered coils, etc., other work in progress... San Diego, CA http://www.ixpres.com/vlusardi/chevtrk.htm [This message has been edited by bigvinnie (edited May 15, 2002).] [This message has been edited by bigvinnie (edited May 15, 2002).] [This message has been edited by bigvinnie (edited May 15, 2002).]
__________________
'72 short step, 350, 700R4, tilt, ps, pdb, a/c, lowered coils, etc., other work in progress... San Diego, CA 72 Stepside Project |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|