|
|
|
03-17-2009, 05:45 PM
|
#1 |
|
Account Suspended
 
Join Date: Jun 2007
Location: Claremore, Oklahoma
Posts: 821
|
Dash Help
Ok, po installed an ammeter and aftermarket water temp gauge. I want to get rid of those and have my factory gauges work. Does in all work though the circuit board on the back or do I have to run wire to the voltmeter and temp gauge?
Thanks in advaned and a master wiring diagram would be grest too. Lost it when I switched to new computer. |
|
|
|
03-17-2009, 07:47 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Dash Help
The circuit board on the back is what is used for the gauges. Of course the underdash harness and the underhood harness have to have the necessary wires in them.
Here is a link to the wiring diagrams. Jim http://www.geocities.com/chevroletc1070/wiringdias.html
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
