Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
08-05-2009, 08:35 PM | #1 |
Active Member
Join Date: Jun 2005
Location: Idaho
Posts: 263
|
automatic linkage bushing
My automatic linkage HAD a bushing that fits in the lower part where the rod goes from the column down to the rest of the linkage. Mine was so bad it crumbled and fell apart. It's plastic, and does anyone know where I can get one? I checked the LMC catalog and zippo. I could try a couple junk yards but a new one would be the ticket. Let me know if you know of a source for one. Thanks
Jim |
08-05-2009, 11:03 PM | #2 |
Registered User
Join Date: Jul 2007
Location: New River Arizona
Posts: 1,180
|
Re: automatic linkage bushing
The bushings are usually metal and fit snugly intu a rubber grommet. I have used grommets from the small parts bins at Ace or Tru value hardware stores and then cut a sleeve from some small tubing slide the rod throgh and place a flat washer followed by a cotter pin.
|
08-05-2009, 11:22 PM | #3 |
Registered User
Join Date: May 2007
Location: new jersey
Posts: 610
|
Re: automatic linkage bushing
try www.classicparts.com, part number 91-064 may be what you're looking for, not sure though ??
LUCKTRUCK |
08-05-2009, 11:55 PM | #4 |
Registered User
Join Date: Jan 2006
Location: Take Off
Posts: 1,908
|
Re: automatic linkage bushing
NAPA might carry it in the Dorman line of goodies.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|