![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Jul 2007
Location: Fall River California
Posts: 2,026
|
Rebuilt Gauge cluster, gas gauge issue
I just rebuilt the dash in my 72 4X4 and when I reinstalled it the gas gauge wont register accurately, I filled the tank today and the gauge only went up to 1/3rd tank. It worked perfect before I rebuilt the cluster. I know I didnt damage anything in the gauge when I cleaned it all up. I did repaint the needle but was very careful when I did it. I did move the needle to mask the gauge face while I painted the needle, I was very careful. Does the needle need to be set in a special position or something when assembled? I have done this to two of my other trucks without any problems. When I reinstalled the gauges the needle was in this position, the next time I drove it it went down to almost empty which was the correct reading, when I filled it up it went to just over 1/3rd tank. I hope this isn't too much info! Here are a couple pics, I repainted the face, polished the lens, painted the needles with fluorescent paint, repainted the lettering (Lights/ windshield wiper) replaced all the bulbs and cleaned the faces of each gauge
Any suggestions would be greatly appreciated. Aaron ![]() ![]() ![]() |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Sep 2008
Location: CASA GRANDE AZ
Posts: 4,276
|
Re: Rebuilt Gauge cluster, gas gauge issue
Did you take the needles off to paint them
__________________
70 SWB STEPSIDE 70 BLAZER 09 challenger |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|