|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
05-22-2002, 04:48 PM
|
#1 |
|
Registered User
Join Date: Oct 2001
Location: Canton, MI
Posts: 55
|
rear end and driveshaft question
I recently swapped my 12 bolt rear end out for a dana 60. I'm going to be putting the driveshaft back in soon, but before i do, I want to make sure it will fit. Do i need to have it shortened because of the different rearend, and by how much? or is it the same driveshaft length for the 12 bolt and dana 60?
Thanks, Dave
__________________
68 long fleetside 67 camaro 83 monte carlo 88 SS monte carlo |
|
|
|
05-23-2002, 02:45 AM
|
#2 |
|
"Trucks with Class"
 
Join Date: Jul 2000
Location: OLYMPIA, WA, USA
Posts: 8,158
|
Measure three times & cut once! Be careful of different ujoint/yoke sizes from one to the other. You are probably going to have to build a custom driveshaft or find the correct one that comes out of a 3/4T PU with the same trans as yours. Be sure and get the center bearing mount, it will also be different.
|
|
|
|
|
05-23-2002, 08:03 PM
|
#3 |
|
Senior Member
Join Date: Apr 2000
Location: Orlando, FL
Posts: 1,076
|
If you measure from the center of the axle to the center of the yolk it would give you a pretty good idea on the difference between the two. As mentioned though you might have to change the yolk to match your universal and/or get a conversion universal joint. Maybe everything will just fit. When I swapped mine out I didn't have to do anything.
------------------ Orlando,FL 72 Chevy 4x4 3/4T CustomCamper w/SB 406
__________________
............................................................ 68 Chevy CST SWB w/LS1, carb & 700r4. Golden Anniversary clone with a few improvements. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
