|
|
|
03-27-2010, 04:15 PM
|
#1 |
|
Registered User
Join Date: Mar 2010
Location: Cullman Alabama
Posts: 56
|
Intake
Will my stock Q-jet fit on a new edelbrock intake?
Thanks
__________________
71  C-15 350 three speed.
|
|
|
|
03-27-2010, 04:24 PM
|
#2 |
|
Between Trucks...
Join Date: Mar 2002
Location: Los Angeles, CA.
Posts: 3,830
|
Re: Intake
Depends on which intake. You want an intake that accepts a spreadbore carb. Also the intake might not have provisions for divorced choke on the carb.
__________________
Beat it to fit, Paint it to match... 
Last edited by Sinister; 03-27-2010 at 04:26 PM. |
|
|
|
|
03-27-2010, 04:36 PM
|
#3 |
|
Registered User
Join Date: Mar 2010
Location: washington
Posts: 274
|
Re: Intake
you could always run the adapter on it if it doesn't
|
|
|
|
|
03-27-2010, 05:17 PM
|
#4 |
|
What?
Join Date: Jun 2007
Location: Southern California
Posts: 7,617
|
Re: Intake
I ran a Q-jet on a Performer for years, and had great luck with that set up.
Though I do remember being picky about base gaskets, IIRC I tended to use the base gasket that was thick cardboard material. Just be sure that you have good seal contact, since the thin flimsy gaskets never worked well for me.
__________________
Chris 1968 K20 Suburban 1972 K10 LWB PU |
|
|
|
|
03-27-2010, 06:05 PM
|
#5 |
|
20' Daredevil (Ret)
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,722
|
Re: Intake
My Q-jet has been sitting on an Edelbrock 2101 Performer for quite a few years with no issues.
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
