|
|
|
04-28-2010, 12:22 PM
|
#1 |
|
Registered User
 Join Date: Apr 2010
Location: Dallas, TX
Posts: 94
|
Measuring Tailshaft?
I measured my Turbo 350 tranny tailshaft to see if it was 9" for my 700r4 swap. I measured from where it bolts to tranny to end of yolk. It is 9" between those two points. Did I measure it correctly? If so, the 700r4 is an easy swap with just moving the crossmember, Correct?
|
|
|
|
04-28-2010, 01:34 PM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Measuring Tailshaft?
no you didnt measure right// its from to the end of the casting ,yoke is additional
the original tailshafts in these trucks were all 6"tailshafts you need to move the crossmember and shorten driveshaft
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
04-28-2010, 03:39 PM
|
#3 |
|
Registered User
Join Date: Dec 2008
Location: Gastonia,NC
Posts: 137
|
Re: Measuring Tailshaft?
Here is a picture showing the correct measurements.
__________________
Tim |
|
|
|
|
04-28-2010, 03:42 PM
|
#4 |
|
Registered User
Join Date: Apr 2010
Location: Dallas, TX
Posts: 94
|
Re: Measuring Tailshaft?
Thanks you very much. Mine is 6". Guess if I run the 700R4, I will have to have driveshaft shortened. Bummer.
|
|
|
|
|
04-28-2010, 03:44 PM
|
#5 |
|
Registered User
Join Date: Apr 2010
Location: Dallas, TX
Posts: 94
|
Re: Measuring Tailshaft?
Hey CDowns, If I run the 200-4R, I don't have to modify driveshaft, is that right?
|
|
|
|
|
04-28-2010, 04:12 PM
|
#6 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Measuring Tailshaft?
no driveshaft mods required for the 224R just reposition crossmember
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
04-28-2010, 04:32 PM
|
#7 |
|
Senior Member
Join Date: Sep 2007
Location: Albuquerque NM
Posts: 7,858
|
Re: Measuring Tailshaft?
is your truck a long or short bed? I m having to cut my d/s 3". (longbed)It was cut previously for a long tailshaft 350.
__________________
1967custom |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
