Sanderson Header question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Lippyp · 06-09-2010, 10:57 AM

I've just spotted a pair of nearly new Sanderson block hugger headers on UK Ebay and I'm wondering if they would a: fit my truck and b: would offer any real gains over the ramshorns I currently have on there, obviously I'd also have to redo the entire exhaust at the same time so it fits but they could go into my parts stash if they go for the right price. Is there likely to be a part/model number on them anywhere I could get the vendor to check? My 350 is in the six cylinder position so that may make a difference re hitting crossmembers etc.

This is them

06-09-2010, 10:57 AM	#1
Lippyp English Chevy Owner Join Date: May 2002 Location: Shropshire, UK/ Lot, France Posts: 1,848	Sanderson Header question I've just spotted a pair of nearly new Sanderson block hugger headers on UK Ebay and I'm wondering if they would a: fit my truck and b: would offer any real gains over the ramshorns I currently have on there, obviously I'd also have to redo the entire exhaust at the same time so it fits but they could go into my parts stash if they go for the right price. Is there likely to be a part/model number on them anywhere I could get the vendor to check? My 350 is in the six cylinder position so that may make a difference re hitting crossmembers etc. This is them __________________ Phil '67 C10 long fleet. 350/TH350, 4 bbl Carter, K&N, Dual exhaust, loads of stuff coming soon 2001 S10 Blazer Daily Driver, bone stock 4 door 4x4 with manual transmission

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.