PA Great Parts for Sale!

[72longbed]

Two piece driveshaft and carrier bearing assembly was just freshly built before removing from my 2wd chassis. Freshly built from all Spicer Heavy-Duty 1350 U-joints, Yokes, Slip Yokes, New Carrier Bearing Assembly, and new Tubes. Was bolted to a GM 14 Bolt FF rear and 700R4 trans up front. This assembly is Heavy Duty, Balanced, Very Few miles, and Complete end to end. Anybody who has had a 2 piece driveshaft assembly built right for one our trucks knows how much money I have into this baby.

It can be adapted to fit any two piece driveshaft configuration 67-72 trucks, C10 or C20. I can supply measurements to interested members.

I'll let it go for $200.00.

It will be shipped in a tube to your door.

Thanks,
72longbed

[mac72]

interested
Need meas. from front cap center to carrier center,the same for the rear & overall cap to cap Thanks Mac

[72longbed]

mac72,
these are 'approximate' measurements:

Center of carrier bearing to Center of REAR U-joint = 40 1/4"
(now keep in mind there is a Slip-Joint just after the center carrier bearing and that seems to be about in the middle of it's travel. It is adjustable about 3 or 4" in and out.)

Center of carrier bearing to Center of FRONT U-joint = 26 1/2"
(keep in mind that there is a Slip-on yoke just ahead of that front U-joint that goes into the transmission. It is 7" long.)

Hope these measurements help. It is about 10 degrees today out in the garage that I have these stored in. I'm only going outside again on the deck for more wood for the fireplace.

Too Cold ......

[72longbed]

ttt

[mac72]

I'll chk. my meas. tomorrow when I get to work.