|
|
|
05-24-2011, 01:49 AM
|
#1 |
|
Registered User
Join Date: Nov 2008
Location: Rowlett, TX
Posts: 867
|
Power Seats Wiring?
Hey guys, I am gonna install bucket seats out of a 95 Chevy Z71 truck, and the driver side is Power bucket. Does anyone know what it would take to wire this one seat up in my 71 Burb? Is it just hot and ground? Thanks in advance!
|
|
|
|
05-24-2011, 01:52 AM
|
#2 |
|
Big Red - Now its a SWB!
Join Date: Jun 2009
Location: Oroville, Ca
Posts: 1,624
|
Re: Power Seats Wiring?
Seems like that is all it will take if you want it hot at all times like factory, just make sure to use whatever size wire and fuse they had in the 95.
__________________
68 3/4 ton  (Project)-350 Small Block, .030 over, 10:1 comp, 3998993 heads, C3BX edelbrock intake, comp cams XE268, Holley 670 SA, long tube headers, dual flow 40's, E-fan, Alum rad, currently under the knife getting shortened and bagged  build thread41 3/4 ton (wife's)-flatbed, fully restored to original01 Tahoe LT 4WD (my daily driver)-Magnaflow Muffler, Rollin on 22's 02 Ford Mustang Convertable (Wife's Car)-Flowmaster 50, Clear corners, Intake, sittin on 18's |
|
|
|
|
05-24-2011, 02:24 AM
|
#3 |
|
Registered User
Join Date: Nov 2008
Location: Rowlett, TX
Posts: 867
|
Re: Power Seats Wiring?
yeah....I looked over in the 88-98 section and seems to be three wires...2 hot for seat movement and lumbar movement, and one black for ground. Thanks for the help bud!
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
