A little bit of progress - The 1947 - Present Chevrolet & GMC Truck Message Board Network

pritch · 06-10-2012, 06:29 PM

I finally got my chassis down off the barrels it's been sitting on and on it's own four feet!

I wasn't totally sure these straps & engine puller were up to the task, but it worked out OK.

Now I can install my motor and trans.

rsavage · 06-10-2012, 09:10 PM

Excellent! Keep us posted on further progress.

**med.bronze** · 06-10-2012, 09:22 PM

The barrels and 4x4 were actually a good idea!

pritch · 06-11-2012, 10:07 PM

Quote:

Originally Posted by med.bronze

The barrels and 4x4 were actually a good idea!

Thanks. It sure did save a lot of bending down. Got everything up where it was comfotable to work on.

06-10-2012, 06:29 PM	#1
pritch Registered User Join Date: Mar 2004 Location: Hoytsville, Utah Posts: 3,365	A little bit of progress I finally got my chassis down off the barrels it's been sitting on and on it's own four feet! I wasn't totally sure these straps & engine puller were up to the task, but it worked out OK. Now I can install my motor and trans. __________________ '68 Panel Project Boogie Chillin' '68 C-10 Ol' Green

06-10-2012, 09:10 PM	#2
rsavage Registered User Join Date: Aug 2009 Location: Alden NY Posts: 2,705	Re: A little bit of progress Excellent! Keep us posted on further progress. __________________ 1961 C1 Corvette 1959 El Camino 350 TPI, 9" 4 w disc 69 Blazer K5 - sold July '20 2021 Durango RT 5.7

06-10-2012, 09:22 PM	#3
med.bronze Senior Member Join Date: Dec 2011 Location: Laurel, Mt. Posts: 522	Re: A little bit of progress The barrels and 4x4 were actually a good idea! __________________ 1972 Cheyenne Super 10 SWB,bucket seats,dealer cruise,tilt,tac,a/c,shoulder belts, 350/350 1971 K-10 Custom Deluxe 1971 K-10 Custom

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.