![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Jun 2002
Location: DFW, TX
Posts: 1,680
|
Return Spring/Kickdown Cable Setup
Anybody have a picture of how their return spring is setup on either a Edelbrock or Carter carb? I just changed out my Holley for a Carter and can't seem to get the return spring to work right when my kickdown cable is hooked up. I took the kickdown cable off because I need a new one so now I have the return spring sitting on that linkage on the carb.
Thanks!
__________________
Scott Shelbourne Last edited by BigRed; 06-12-2003 at 12:01 PM. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jun 2002
Location: DFW, TX
Posts: 1,680
|
Ok, I don't necessarily need pics, but how about a description.
![]()
__________________
Scott Shelbourne |
![]() |
![]() |
![]() |
#3 |
Alleged Member
Join Date: Jul 2003
Location: Athens, AL
Posts: 79
|
They sell hookups for the carter/edelbrock. In a pinch I hooked one up to the top of the linkage and pulled it forward to anything there it could be fastened to. I tried the thermostat hose clamp and it worked good.
:gwc: :gwc: :gwc: :gwc: :gwc: :gwc: |
![]() |
![]() |
![]() |
#4 |
BAD BOW-Silverado XST
Join Date: May 2000
Location: Senior Member from Austin, TX
Posts: 6,431
|
Does this help? The adaptor should be in the carb box.
![]() PS- I have discovered that the square bores carbs need this adaptor. This will keep the kickdown or TV cable fully extended at WOT. |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Jun 2002
Location: DFW, TX
Posts: 1,680
|
Actually, this is a slightly old thread. I did rig the return cable up and have it routed forward instead of backwards like it was before. Thanks!
__________________
Scott Shelbourne |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|