|
|
|
07-10-2013, 11:53 PM
|
#1 |
|
Senior Member
Join Date: Jan 2002
Location: calgary,Alberta,Canada
Posts: 387
|
Big Block Exhaust
Hi all,
It has been a long time since being on the site. I apologize if this has been covered in the past but I can't seem to find the right information. I would like to purchase a 2.5" Stainless dual exhaust system for my 1972 Shortbed. I have a factory 402 and I want to use the factory manifolds. Here is the most complete kit I have seen online: http://www.magnaflow.com/02product/s...ne=all&id=1333 The trouble with this kit is that it does not have the downpipes included. Does anyone know where I could get a 2.5" Stainless Steel Mandrel Bent system from front to back or even get the pre bent downpipes to fit this magnaflow system? Any help or advice would be appreciated. Attached is a picture of my truck. Cheers, Curtis
__________________
1972 CHEYENNE SUPER SWB BLACK. 402 BB, TH400, AIR, TILT, TACH, BUCKETS, CRUISE, AM/FM, 8 TRACK. My build thread: http://67-72chevytrucks.com/vboard/s...=1#post7120181 |
|
|
|
07-11-2013, 12:11 AM
|
#2 |
|
Registered User
Join Date: Jun 2013
Location: Manteca ca
Posts: 4
|
Re: Big Block Exhaust
Honest opinion have an exhaust shop build u a system instead of a kit. Kits r based off one vehicle and custom will fit your truck so much better. And then u also have options especially when it comes to ground clearance, oil filter clearance and starter.
Posted via Mobile Device |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
