![]() |
|
![]() |
#1 |
Registered User
![]() Join Date: Feb 2004
Location: brownfield texas (west texas)
Posts: 1,936
|
pinion yoke?
Alright guys im fixing to get my driveshaft made and i ran into an issue. I really need to step up to a 1350 pinion yoke but 70 bucks is the cheapest im finding on top of 275 to get the shaft done wow that hurts! Any one know where to get them cheaper and 2nd is there a donar rear where i could get one that will fit the 12 bolt? Thanks for your imput!!!
Posted via Mobile Device
__________________
The Ghost 67 short wide full custom. 550 hp LSX, 4l80E, narrowed 9". Body dropped w/air ride! ........................ ___ .........________//__{\_____ ,,,,,,,/__(⊙)___//___/__(O)_/ @disciple2.rc 💪instagram💪 LED TAILS |
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: pinion yoke?
I can only imagine what you have invested so far by putting in a LSX and the rear end work , plus other stuff you have listed , are you really worried about 70 bucks and 275 for a drive shaft?? Sometimes it is best to pay a little more to get quality, esp. when you are talking HP and TQ
Probably not what you where wanting to hear, but i had to chime in after i read you list of upgrades
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks ![]() |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|