tie-rod bar question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

blue402 · 07-13-2003, 11:28 PM

Is the actual tie rod bar supposed to have a slight bend, or should it be perfectly straight. My bar bows towards the front of the truck. Thanks for your help!

**COBALT** · 07-14-2003, 12:34 PM

You mean the drag link? The bar with the 4 holes that connect to both tie rods, the idler, and the pitman? If so yes it's straight between the inner two holes, but it bends at about 10-15 degrees on the ends to the outer holes.

blue402 · 07-14-2003, 07:07 PM

Thanks for your help. That is it. I guess I did't know it was called a drag link.

**COBALT** · 07-14-2003, 08:15 PM

Cool. Make sure if you're taking it out you remember how it goes back in. I made a little mark next to the pitman arm stud hole (arrow pointing up) that told me how it went back in the truck. Not too many of the pictures i've seen really show how it's supposed to go...

07-13-2003, 11:28 PM	#1
blue402 Registered User Join Date: Jul 2003 Location: Omaha NE Posts: 4	tie-rod bar question Is the actual tie rod bar supposed to have a slight bend, or should it be perfectly straight. My bar bows towards the front of the truck. Thanks for your help!

07-14-2003, 12:34 PM	#2
COBALT Senior Member Join Date: Sep 2001 Location: Seattle, WA, USA Posts: 5,817	You mean the drag link? The bar with the 4 holes that connect to both tie rods, the idler, and the pitman? If so yes it's straight between the inner two holes, but it bends at about 10-15 degrees on the ends to the outer holes. __________________ '69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA.

07-14-2003, 08:15 PM	#4
COBALT Senior Member Join Date: Sep 2001 Location: Seattle, WA, USA Posts: 5,817	Cool. Make sure if you're taking it out you remember how it goes back in. I made a little mark next to the pitman arm stud hole (arrow pointing up) that told me how it went back in the truck. Not too many of the pictures i've seen really show how it's supposed to go... __________________ '69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-14-2003, 07:07 PM	#3
blue402 Registered User Join Date: Jul 2003 Location: Omaha NE Posts: 4	Thanks for your help. That is it. I guess I did't know it was called a drag link.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.