|
|
|
07-03-2014, 09:00 PM
|
#1 |
|
Registered User
Join Date: Feb 2012
Location: Mission Viejo, CA
Posts: 1,856
|
cab trim rivets
Can I just cut off and grind down the little tab thingys on the back of the cab under the window?
Is it a rivet thats going to fall out later or is it some kind of weld? 
|
|
|
|
07-03-2014, 09:15 PM
|
#2 |
|
Member #1049
Join Date: Jun 2000
Location: Troy Montana
Posts: 3,940
|
Re: cab trim rivets
its a welded on stud, cut away
|
|
|
|
|
07-03-2014, 09:19 PM
|
#3 |
|
Registered User
Join Date: Sep 2007
Location: Riverside, CA
Posts: 4,316
|
Re: cab trim rivets
it is two tone trim separating studs...so if you are going two tune...score the trim and use those!
|
|
|
|
|
07-03-2014, 10:38 PM
|
#4 |
|
Registered User
Join Date: Feb 2012
Location: Mission Viejo, CA
Posts: 1,856
|
Re: cab trim rivets
I have the trim. Looks really nice. Not going to reuse it. Probably put it on the parts board at some point.
I ground those things down and they disappeared into the surrounding metal so looks like its good to go. thanks |
|
|
|
|
07-03-2014, 11:24 PM
|
#5 |
|
Registered User
Join Date: Oct 2008
Location: Marianna Arkansas
Posts: 7,279
|
Re: cab trim rivets
A lot of people don't know this but there is a tip that goes into the end of the stud gun dent puller system that is made to reinstall those rivets along the places like that where the divider chrome goes and the windshield chrome retainers clips as well. Some people put the clips on with a screw, not to say that is incorrect but it is more holes in a body that is apt to corrosion anyway. The truck where I had some damage to the area I removed the rivet, repaired the damage, and then replaced the rivet before the part was put back on. Jim
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
