![]() |
|
![]() |
#1 |
Registered User
Join Date: Jul 2014
Location: Enfield NH
Posts: 31
|
engine swap
I just put a new 408sbc in my 86 C10, and the temp gauge pegs out after it has run for a few minutes, but engine doesn't seem to be running hot. I even took it down the road a couple of miles. The temp sensor was in it from the shop, and is new, any ideas ?
Thanks Carnut |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Aug 2011
Location: Gallatin, TN
Posts: 782
|
Re: engine swap
Bad gauge?
__________________
77 C10, 6.0LS/4L80E, 3:73 12 bolt. Boss 338's 20" x 10" w/ 285/50/20 rear. 20" x 8.5" w/ 245/40/20 front. Vintage Air. Full Autometer gauges recessed in factory bezel (Thanks bigblock73!) Gm Storm Grey Metallic paint "Cool ain't ever cheap and cheap ain't ever cool" |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jul 2014
Location: Enfield NH
Posts: 31
|
Re: engine swap
it worked fine prior to the swap ?
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Jan 2013
Location: Jasper, IN
Posts: 948
|
Re: engine swap
Get an infared hear gun before anything more. I wouldn't risk it getting hot with no temp guage. Couls be bad wiring, sendor or guage, but i wouldn't run it until knowing temps, and even then only a little until a reliable guage is installed.
__________________
When in doubt, throttle it out! 1974 Chevrolet Custom K20 2005 Ford Ranger Edge 1985 Chevrolet Custom Deluxe C10 |
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Jul 2014
Location: Enfield NH
Posts: 31
|
Re: engine swap
Thanks, it ended up being the sensor.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|