|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
01-25-2015, 08:05 PM
|
#1 |
|
Registered User
Join Date: Jul 2012
Location: Bay Area, Ca
Posts: 108
|
Oil dipstick tube removal?
I need someone that has a little experience with the dipstick tube/heat stove.
I'm fighting the install of my heat riser stove outside cover piece. It seems it would fit except the oil dipstick tube is in the way. Either I have to pull it, or figure out how to trim away part of the shield case (last resort). Or lift the engine, or ??? Do you typically pull the tube out of the block? Is it reusable then? Seems to me the shield should slide right on, and then comes the fight to reinstall the lower screws. I've got the original spark plug shields there too. Any ideas?
__________________
1971 C-10 307 3OTT |
|
|
|
01-25-2015, 08:25 PM
|
#2 |
|
Registered User
Join Date: Jul 2012
Location: Bay Area, Ca
Posts: 108
|
Re: Oil dipstick tube removal?
I apologize for wasting bandwidth. I looked at again after a break and voila!
__________________
1971 C-10 307 3OTT |
|
|
|
|
01-26-2015, 02:56 PM
|
#3 |
|
Registered User
Join Date: May 2013
Location: Central NC
Posts: 830
|
Re: Oil dipstick tube removal?
Sometimes you just have to talk things out.
__________________
1972 Cheyene C-10 "Ole Green" My Grandfathers truck (early 70's to 1983) My first vehicle (1983) Original 350 (3 rebuilds) 700R4 from Bowtie Overdrives 
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
