![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Dec 2014
Location: McDonough, Ga
Posts: 87
|
Muncie 318 rebuild attempt (advice welcomed)
I'm going to attempt a rebuild on a Muncie 318 (3 speed) from my '68 C10. I have never messed with a transmission before, so this could get interesting. Here's a few pictures of where I'm at so far. Trying to figure out my next step... I looked online to see if I could find some help, & I did find a diagram that is close (but I think it might be for a 4 speed...idk).
![]() ![]() ![]()
__________________
'68 Chevy C10 '06 Saleen Mustang #725 (Convertible) ![]() '04 Infiniti G35 '01 Infiniti QX4 |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Aug 2010
Location: Edwards, CA
Posts: 7,503
|
Re: Muncie 318 rebuild attempt (advice welcomed)
Do you have the factory overhaul manual?
http://www.mediafire.com/download/?fwv5m5vr8zslvma RTFM ... Read The Factory Manuals... download 'em here
__________________
Thanks, Tim * VIN/Model Decoders * Power Team Charts (engine/transmission/gear ratio) * Post Your Pickup SPID ** Blazer SPID ** Suburban/Panel SPID * RTFM ... Read The Factory Manuals... download 'em here Highlanders ** Do you have a 1972 Plaid Pickup? ** Plaid Blazer ** Plaid Suburban |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Nov 2009
Location: Michigan
Posts: 474
|
Re: Muncie 318 rebuild attempt (advice welcomed)
Tips: Take pictures as you take it apart. Use grease to hold the roller bearings in place inside the cluster gear while you install the center pin.
__________________
Brad handshoe |
![]() |
![]() |
![]() |
#4 | |
Registered User
Join Date: Dec 2014
Location: McDonough, Ga
Posts: 87
|
Re: Muncie 318 rebuild attempt (advice welcomed)
Quote:
![]()
__________________
'68 Chevy C10 '06 Saleen Mustang #725 (Convertible) ![]() '04 Infiniti G35 '01 Infiniti QX4 |
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|