![]() |
|
![]() |
#1 |
Registered User
Join Date: Nov 2001
Location: Malaga, N.J.
Posts: 171
|
wiring nelp
![]() for a electronic ignition. Can't get the truck to start with the key I'm just lost HELP. changed from point to electronic ignition ![]()
__________________
C/10 John N.J. |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
first thing is you eliminate the yellow wire at the starter, then you take the yellow wire at the coil go back thru the wire loom find the spot in the firewall junction box it goes to then remove it and replace it with a new length of 12gauge wire and you'll be good to go . the reason you have to replace the original is that the original wire is a resistor and only supplys 7volts to the coil
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
![]() |
![]() |
![]() |
#3 |
Glowing since 1978
Join Date: Mar 2001
Location: Lusby,MD,USA
Posts: 532
|
__________________
66 Chevy C30 Stakebody Dump, PS,PB, 327cu in 71 Corvette Coupe 454 4 speed 69 Chevy C20 Custom Camper |
![]() |
![]() |
![]() |
#4 |
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Do you have the wire in the proper terminal on the HEI cap?
If everything looks good, then check your plug wires and make sure the fireing order is right and that they are in the correct location. |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|