|
|
|
07-11-2015, 12:06 PM
|
#1 |
|
Registered User
 Join Date: Feb 2003
Location: Marshfield, MO
Posts: 355
|
3 Speed Question
About ready to put the transmission back in today. Had to pull the tail shaft off because we dropped the darn speedo gear in there - opps! Trying to make sure I am in neutral and that the shifter forks are in the right spot. Both ends (front spline and tail shaft) turn freely and independently. Before I put it back in, should I put a drill bit in the alignment holes on the steering column?
|
|
|
|
07-11-2015, 02:10 PM
|
#2 |
|
Registered User
Join Date: Dec 2014
Location: Sedro Woolley Washington
Posts: 86
|
Re: 3 Speed Question
If both the front and tail shaft spin independent of each other then you're in neutral.
__________________
72 Chevy C20 LWB-Just what I always wanted. Now, just need more time and money! |
|
|
|
|
07-11-2015, 03:05 PM
|
#3 |
|
Registered User
 
Join Date: Jul 2007
Location: New River Arizona
Posts: 1,180
|
Re: 3 Speed Question
If you did not screw the linkage in or out there should not be a need to adjust it but you could do it just to be sure.
|
|
|
|
|
07-11-2015, 03:12 PM
|
#4 |
|
Registered User
Join Date: May 2014
Location: Manteca, Ca.
Posts: 274
|
Re: 3 Speed Question
If the shifter worked good before it should shift good now. But what the heck, good time for an alignment check anyway. It will not take but a couple extra minutes.
Might be a good time to check the play in the column and replace all of the bushings in the lower unit.
__________________
Terry Soon to be retired and moving to Bristol, TN. |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
