aftermarket trail arm question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Metaldoc · 09-03-2015, 11:40 AM

Should there be a drain hole on the bottom of the bend? I made mine close to CPP trail arm and the bent end is sealed, but not the bushing end.

*Fitz* · 09-03-2015, 12:53 PM

Quote:

Originally Posted by Metaldoc

Should there be a drain hole on the bottom of the bend? I made mine close to CPP trail arm and the bent end is sealed, but not the bushing end.

Drill 'em if you want to. Unless you dipped them in primer they will rust from the inside to the outside.

09-03-2015, 11:40 AM	#1
Metaldoc Registered User Join Date: Apr 2015 Location: Ayr Ontario Posts: 1,122	aftermarket trail arm question Should there be a drain hole on the bottom of the bend? I made mine close to CPP trail arm and the bent end is sealed, but not the bushing end. Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.