CA WTB speed warning harness & gear.

[cheyenne shortstep]

I need a wiring harness and one of the fiber gears (the one that the plastic face screw goes through) and 2 plastic screws. Let me know what you've got.
Thanks, Tremayne.

[leddzepp]

Tremayne- I have the correct nylon screws (4/48x3/8) the only difference is that they are round head and the OEM were pan head. When installed you can't even tell, unless you know this already and have and monacle When I needed screws to rebuild a couple speedwarnings, these were all I could get from a machine shop and I had to buy 100 of them I can also PM you info on how to machine a new set of those fiber gears in brass so they never break or chip again. Those two gears (a weak point IMO) are slightly different in thickness (as you probably already know), but they are the same oddball pitch/tooth count.

[cheyenne shortstep]

Scott, I'll take a couple of the screws, it doesn't matter to me if they are a little different and you're right they'll never be noticed. I'd love to have the specs for making the gears out of brass my buddy could make these for me.
Thanks, Tremayne.

[leddzepp]

Pic. I took the liberty of dying some with Krylon fusion.

[cheyenne shortstep]

Scott, I got the screws yesterday and they look great thank you.
I'm still looking for a harness and gears.

[1rippen6]

I bought a repop harness off a forum member I can look at the package and see if I can figure out where he bought it if interested.

[cheyenne shortstep]

1rippen6, thanks for the offer but I'll hold out for an original.