Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
05-08-2017, 10:41 PM | #1 |
Registered User
Join Date: Apr 2016
Location: Denver CO
Posts: 129
|
Vent window seal replace
Hey all,
I have read that some owners bend the frames open enough to slip the new seal into and then use a vise or other device to clamp it back together. Has anyone used dish soap or is the bend/clamp method easier? Here is my brief write up since there isn't one specific for 60-66 which don't use a pivot style rivet half way up the frame. I used my dremel to grind off the lower 2 rivets at the base of the frame that hold the curved frame to the straight leg. Once that is done it can pivot slightly on the single rivet located at the top of the frame and allows you to remove the window (the frame has a little flex in it that you have to use to pop it out). Once that is done, you can remove the small Phillips screw located in the bottom of the felt channel and peel out the old seal. Thanks in advance... |
05-09-2017, 12:34 AM | #2 |
Registered User
Join Date: Mar 2011
Location: garden grove
Posts: 175
|
Re: Vent window seal replace
Forgive me if Im not following you directly here, but you want to replace the vent seal, right? It is a pain for sure. But you dont have grind anything or remove rivets at all to get the new seal on. Remove the tension spring nut on the bottom which will allow you to pull the glass out of the frame housing. Then make the little incision for the small housing bracket 2/3's the way up where it screws into the inside door frame and slip the rubber on. Now for getting the rubber pressed into the housing, lots of patience and some WD40 usually does the trick. I usually get a medium sized very dull flat head screw driver and start at the upper section and push in one bottom squared angle of rubber and then push in the other side and work my way down in increments. You can do this with the unit in the door or out. I find it easier to get the rubber into the frame after Ive installed the unit into the door because you are still going to have to mess with gettin the rubber to over lap on the outside of the door skin for a water tight seal, being extremely careful with the screwdriver if there is fresh paint. Good luck.
|
05-09-2017, 10:13 AM | #3 | |
Registered User
Join Date: Apr 2016
Location: Denver CO
Posts: 129
|
Re: Vent window seal replace
Quote:
|
|
05-09-2017, 10:17 AM | #4 |
Registered User
Join Date: Mar 2011
Location: garden grove
Posts: 175
|
Re: Vent window seal replace
Youre working on a 64-66?
|
05-09-2017, 10:34 AM | #5 |
Registered User
Join Date: Apr 2016
Location: Denver CO
Posts: 129
|
Re: Vent window seal replace
|
05-09-2017, 10:44 AM | #6 |
Registered User
Join Date: Mar 2011
Location: garden grove
Posts: 175
|
Re: Vent window seal replace
Im not familiar with the 60-63's vent windows. And you are right. Looking in the -63 shop manual, no specific outline for the rubber replacement. Just a vague pictureless description on how to install the whole unit and minor adjustments.
|
01-11-2018, 02:36 PM | #7 |
Registered User
Join Date: Apr 2017
Location: Ragley, La.
Posts: 137
|
Re: Vent window seal replace
I'm trying to do this also. I just watched a video that looks pretty good.
https://www.youtube.com/watch?v=z2acnZxNZro |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|