|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
05-10-2017, 11:42 PM
|
#1 |
|
Registered User
Join Date: Dec 2011
Location: austin,tx
Posts: 47
|
When I signal left all the lights flash
I was about to add a connection for towing when I ran across a bunch pinched and frayed wires. I started repairing some of the wires when I noticed that when I signal left all the lights flash like Hazzards. I did add a Hazzard switch but only the right side works. Any thoughts?
Last edited by awitate; 05-11-2017 at 12:09 AM. |
|
|
|
05-11-2017, 12:41 AM
|
#2 |
|
Registered User
Join Date: Jul 2013
Location: Phoenix, AZ
Posts: 348
|
Re: When I signal left all the lights flash
Sounds like a grounding issue. Clean and check all grounds. I had a similar "funky" issue and couldn't figure it out until I made sure all grounds to the lights were solid. Redid the tail lt buckets and viola. Hope this helps.
__________________
60 K20, eaton HO52, T221, SM420, Dana 44 closed 78 K20 Burb, 14 bolt, NP205, SM465, Dana 44 open 05 Dodge Ram 2500 5.9 Cummins 4x4 |
|
|
|
|
05-11-2017, 12:45 AM
|
#3 |
|
Registered User
Join Date: Dec 2011
Location: austin,tx
Posts: 47
|
Re: When I signal left all the lights flash
Thanks Vondog,
I guess I know what I'm going to be doing all day tomorrow. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
