![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Senior Member
![]() Join Date: Sep 2016
Location: Omaha Nebraska
Posts: 588
|
Boyd non efi install question
I'll be installing my Boyd tank under my 72 c10 soon and was wondering do I run my roll over vent up the frame into the charcoal canister or just loop the hose and leave it in the rear?? Also should I run hard line along the frame for fuel all the way to tank or is it best to have a short piece of rubber from the tank to the frame?? Thanks
|
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Jul 2015
Location: Fairfax, Missouri
Posts: 1,049
|
Re: Boyd non efi install question
Not sure on the vent, but I'd sure run a short rubber/braided line with filter from tank. Makes pulling it back out a lot easier.
|
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Jun 2009
Location: Belews Creek , NC
Posts: 4,220
|
Re: Boyd non efi install question
I just ran a short an line out and a loop in case you have to drop the tank I ran a hard line to the back then what jcf said made a loop and used all an fittings to make my connections.
__________________
Larry It is easily overlooked that what is now called vintage was once brand new. "Project 68" paypal.me/ldgrant |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|