Front torque specs/rebuild - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Steelydan · 11-19-2017, 02:50 PM

I’m currently putting my front end back together in my 67 c10, I have installed new shafts in the upper and lower control arms and need to know what to torque them too? I have found one forum that says 90 for the upper and 100 for the lower, is this correct? The manual I have says 160 for the top and 260 for the bottom I believe but that seems like over kill? Also can you torque them while already attached to the cross member and with everything else attached?

11-19-2017, 02:50 PM	#1
Steelydan Registered User Join Date: Sep 2017 Location: Springerville Arizona Posts: 16	Front torque specs/rebuild I’m currently putting my front end back together in my 67 c10, I have installed new shafts in the upper and lower control arms and need to know what to torque them too? I have found one forum that says 90 for the upper and 100 for the lower, is this correct? The manual I have says 160 for the top and 260 for the bottom I believe but that seems like over kill? Also can you torque them while already attached to the cross member and with everything else attached?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.