Carrier bearing bracket - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Robert Bergstrom · 09-19-2018, 09:37 PM

I am replacing the 2 piece driveshaft to a 1 piece. Do I grind off the rivitts on the bracket? Will a 3" diameter driveshaft fit? 72 SWB 2 wheel drive.

notsolo · 09-20-2018, 06:31 AM

I center punch and drill the rivets, then punch them out. 3" drive shaft should fit, not a lot of extra space. any drop will also be close. Super clean under cab! Whats the rest of your truck look like?

09-19-2018, 09:37 PM	#1
Robert Bergstrom Registered User Join Date: Mar 2009 Location: Vancouver, WA Posts: 111	Carrier bearing bracket I am replacing the 2 piece driveshaft to a 1 piece. Do I grind off the rivitts on the bracket? Will a 3" diameter driveshaft fit? 72 SWB 2 wheel drive. Attached Images __________________ Vancouver Bob

09-20-2018, 06:31 AM	#2
notsolo Registered User Join Date: Apr 2008 Location: Md Posts: 2,482	Re: Carrier bearing bracket I center punch and drill the rivets, then punch them out. 3" drive shaft should fit, not a lot of extra space. any drop will also be close. Super clean under cab! Whats the rest of your truck look like? __________________ http://67-72chevytrucks.com/vboard/s...d.php?t=635605

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.