Full stock front rebuild - The 1947 - Present Chevrolet & GMC Truck Message Board Network

DieselSJ · 03-04-2019, 02:03 PM

Half way there.

Who designs a suspension with no rubber bushings?

Link to video showing how sloppy it all was -
https://imgur.com/vl9jRvr

Upper and lower shafts, upper and lower ball joints, inner and outer TREs, idler arm and pitman arm.

Previous owner must have taken it to a quick-lube place at one time. 2 of the TRE's had some trace of white grease, as did one of the upper pivots. Yeah, those guys do some quality work. The loose one in the video was so dry that it was galling the shaft.

03-04-2019, 02:03 PM	#1
DieselSJ Registered User Join Date: Jun 2016 Location: Phoenix, AZ Posts: 574	Full stock front rebuild Half way there. Who designs a suspension with no rubber bushings? Link to video showing how sloppy it all was - https://imgur.com/vl9jRvr Upper and lower shafts, upper and lower ball joints, inner and outer TREs, idler arm and pitman arm. Previous owner must have taken it to a quick-lube place at one time. 2 of the TRE's had some trace of white grease, as did one of the upper pivots. Yeah, those guys do some quality work. The loose one in the video was so dry that it was galling the shaft. __________________ 87 R30 CC Dually, TBI 454, NV4500, zero rust barn find 87 Jeep Grand Wagoneer, 6.5 turbodiesel, 700R4 Last edited by DieselSJ; 03-04-2019 at 02:09 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.