![]() |
|
![]() |
#1 |
Registered User
Join Date: Jan 2003
Location: Kelowna B.C. Canada
Posts: 2,048
|
axle seals
I'm doing a gear ratio change, and was wondering if I have to change axle seals or can I just slide the axles back in, there not leaking now, reason I ask is I have to get the axle bearings pressed on and off at a machine shop to change seals don't I?
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: May 2003
Location: Shreveport LA
Posts: 3,170
|
No press necessary if you have the C-clip type axle. The bearings are pressed into the housing & the axles just slip through them. If the seals aren't fairly new, I'd replace them. They're cheap & it's not hard at all if the axles are already out. Be sure to check the axles for grooves (grooves=bad) where the bearings ride.
Last edited by jimfulco; 12-01-2003 at 01:02 AM. |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jan 2003
Location: Kelowna B.C. Canada
Posts: 2,048
|
thanks jimfulco
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|