WA Superlift 6” front lift springs, k10 or k20, rear blocks and u bolts

[randy500]

These seem to be about $400 for the front springs, they are installed but never run.
The rear blocks and u bolts will only work on a k20 and maybe only with the ho52 rear end, i would have to measure a dana 60 to see if its the same tube diameter.

I need $150 plus shipping, i think shipping will be about $150.

[Madkidd007]

Since you just overlooked something I think these Ubolts will work just fine on any Leaf axle. They go around the springs and not the housing like round Ubolts The part that really would make the difference would just be the lower saddles and you just reuse originals anyways. So my point is, should fit all

[randy500]

Originally Posted by Madkidd007

Since you just overlooked something I think these Ubolts will work just fine on any Leaf axle. They go around the springs and not the housing like round Ubolts The part that really would make the difference would just be the lower saddles and you just reuse originals anyways. So my point is, should fit all

Thanks, you are right!

[randy500]

Which means should fit k10 too because they have the same spring width.

[randy500]

Ttt