|
12-10-2003, 12:34 PM | #1 |
Senior Member
Join Date: Jan 2001
Location: Northern Illinois
Posts: 516
|
Bummer !!
I bought a pair of cast aluminum Moroso valve covers on e-bay. The paint didn't look so good so I stripped them. I was having new exhaust manifolds powder coated (I'm going from 2wd to 4wd) The place that does the powder coating was short of work so they offered to coat the 2wd manifolds in the hi temp coating and the brackets and valve covers in satin black, all for a very modest additional fee. The valve covers look beautiful ! I go to install them, they are the tall ones, won't work in the 4wd position. Bummer !
__________________
Bernie |
12-10-2003, 12:36 PM | #2 |
Post Whore
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,686
|
That is a bummer, I imagine using the hammer to make clearance or a short body lift are out?
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
12-10-2003, 12:43 PM | #3 |
Senior Member
Join Date: Jan 2001
Location: Northern Illinois
Posts: 516
|
I seriously thought about the hammer, but I 've redone the cab off the frame in torch red and it would take a lot of pounding to make the covers fit. Also thought of moving the engine forward. Probably just repeat the process with short valve covers.
__________________
Bernie |
12-10-2003, 01:52 PM | #4 |
Registered User
Join Date: Jun 2002
Location: Knoxville Tenn.
Posts: 3,058
|
Cut the corner off cover -have someone weld a flat piece back on -recoat.
__________________
56 Chevy Bel-Air 2dr. HT (purchased new) 71 Chevy Cheyenne SWB PU (502HO) 65 GMC short bed step--work in progress and my gofer |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|