|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
05-22-2020, 10:06 PM
|
#1 |
|
Registered User
Join Date: Jul 2008
Location: Eastern Oregon
Posts: 2,391
|
Carb Exchange Experience
For those who have a QJet or TwoJet or DualJet In need of rebuilding, I wanted to give a shoutout about Joe at Carb Exchange in New Jersey. He recently rebuilt the TwoJet sitting above my 307,71 C/20. Turn around was four weeks door to door. Upon instillation the engine started immediately after a few revolutions, never did that before. I would recommend this company after the experience. The exterior finishes he replicated is amazing.
__________________
71 C-20 07 Magnum RT AWD |
|
|
|
05-22-2020, 10:11 PM
|
#2 |
|
Who Changed This?
 
Join Date: Jan 2013
Location: Simi Valley, CA
Posts: 10,677
|
Re: Carb Exchange Experience
That's a nice looking plating job on that carb! Icing on the cake for one that works right. I would, however, recommend putting a fitting on it that has a bulge on it so that the hose doesn't slide off. I know that there is a clamp there when the hose is installed, but the bulge (or even a barbed fitting) is much nicer for peace of mind, in my book.
__________________
~Steven '70 Chevy 3/4T Longhorn CST 402/400/3.56 Custom Camper Simi Valley, CA |
|
|
|
|
05-23-2020, 10:27 AM
|
#3 |
|
Registered User
Join Date: Jul 2008
Location: Eastern Oregon
Posts: 2,391
|
Re: Carb Exchange Experience
Appreciate your thoughts ! I have the proper hard line from pump to carb, installed this just to check proper operation before I installed it...
__________________
71 C-20 07 Magnum RT AWD |
|
|
|
|
05-23-2020, 10:39 AM
|
#4 | |
|
Who Changed This?
Join Date: Jan 2013
Location: Simi Valley, CA
Posts: 10,677
|
Re: Carb Exchange Experience
Quote:
__________________
~Steven '70 Chevy 3/4T Longhorn CST 402/400/3.56 Custom Camper Simi Valley, CA |
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
