TX New Repair piece for lower right hand side of radiator support

[CS1972]

Made by Member “Clatterville trolley”, see: https://67-72chevytrucks.com/vboard/...d.php?t=817982

[B]I never used mine, was $75.00 shipped CONUS (no PO boxes). $50.00! ..... SOLD

“I have been making these for folks that I sell parts to for some time and thought I might offer a couple to the folks on here.

I hand form these and they come with the weld in nuts and factory OEM bolts.

They are made out of 16 gauge steel - I checked the thickness of the steel in the radiator support with a gauge and they appear to be about 17 gauge, so these are a little thicker than stock.

I constructed them to be long enough to reach under the upright where the rust normally stops unless it is really baaaadddd!

I leave the weld nuts loose so that it allows slight adjustment to line up with the holes in the inner fender front - once you get them where you want them it is easy enough to spot them in.

Right now I only have two made up so that is all I am selling for the moment - not trying to turn this into a business.

Price $75 shipped to you.

First photo shows the replacement piece next to a rusted up one that I removed to replace with new.

Last photo shows where the new repair piece goes on a radiator support.

Works for 67-72 C10 / K10's”

[CS1972]

Well, a few months later and I still have it...........price reduced!

[mikeEboy]

I'm interested. What is the new price?

[Utahboy]

I’ll take it.

[CS1972]

Utahboy,

Sorry for the delay in response, since selling my truck I only check in every couple of days.

Paypal = norlegne@yahoo.com

I received your PM & responded. Send me your address and I'll get it right out.

[CS1972]

Opps.............tried to respond, but received this message: "mikeEboy has exceeded their stored private messages quota and cannot accept further messages until they clear some space"

[CS1972]

Payment received, boxed and UPS tracking sent Via PM. Will drop off tomorrow.