Radiator to Support gap

[PbFut]

I purchased a nice 4 core and electric shroud from Champion. I like the fit and finish. There is a small normal and acceptable gap between the radiator and the support. Though not likely necessary, relative to performance, I would like to finish off the gap with a surround of rubber or foam. Has anyone been down this road and found an acceptable solution?

[Ironangel]

There's these things, https://www.carid.com/trans-dapt/rad...a399cef2f616cc and https://media.lmctruck.com/pdf/CB/cbComplete.pdf They have the radiator cover as well at the bottom of the page

[weq92f]

.

I used a roll of stick on weather stripping. The kind used to seal doors in the house.

-klb

[fun in dirt]

Originally Posted by weq92f

.

I used a roll of stick on weather stripping. The kind used to seal doors in the house.

-klb

Same here!

[PbFut]

Originally Posted by weq92f

I used a roll of stick on weather stripping. The kind used to seal doors in the house.
-klb

That was my first thought. Any issue with the adhesive getting gummy or drying out.?

[weq92f]

Originally Posted by PbFut

That was my first thought. Any issue with the adhesive getting gummy or drying out.?

The stuff fit in the gap pretty tight. The adhesive was useful to stick it where it needed to go so I could get the radiator up against it and bolted down. Now it's just a compression fit. Not sure if the sticky is still sticky and it doesn't appear to be oozing out.

Hth,

-klb

[PbFut]

Thank you sir. Info much appreciated.