![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
drag it like you stole it
Join Date: Feb 2002
Location: Louisiana
Posts: 542
|
ignition switch bezel..
how does it go in the dash, i had bought a new one but it didnt fit in the hole. it was to small. but i dont see how it would work if it was bigger anyways. how does it catch on the inside of the dash? its a 72 dash. thanks
__________________
negative camber //LA\\ |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Jul 2003
Location: Cypress, Tx
Posts: 4,005
|
Thereis a special switch retaining nut you also need. they cost 5.00 from the truck shop in orange , ca. (1-800-243-8947)
Part number 68-04706 Or you can rig it with a bearing shell and a nut like I did(until I get one) Check thier website catalog. Hope this helps!!
__________________
1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|