![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Apr 2006
Location: Hockinson, Washington
Posts: 115
|
Pic Request: Blazer Fuel Tank Swap
Hey guys, going to be doing a swap to remove the old in cab tank, and putting in a Blazer style in the old spare tire area. Have been researching things all ove th e net and have come to the conclusion that some people are really proud of their tanks, and other sell the exact same version. I plan on using my truck as a truck and would also like a bed fill. What I don't want is a bed fill smack dab in the center of where I will be throwing stuff. I have seen the marker light door, and I don't really dig that either. Any way I could do a bed fill but keep it close to the stake pocket steel on the left hand side?
__________________
1968 Chevrolet C-10, 2WD, Longbox, Vortec 350, 700R4, 3.73 gears Good judgment comes from experience, and experience, well......that comes from bad judgment. 1968 Chevy C-10 "Longshot": Bought used from my Uncle George in 1994 and proceeding to beat the hell out of it for 4 years. Sold it. Bought it back, dumped an ungodly amount of money into it since then. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Feb 2009
Location: arroyo grande, ca
Posts: 206
|
Re: Pic Request: Blazer Fuel Tank Swap
Be careful which tank you get. I bought one of those poly "blazer tanks" and minor trimming was required, and as far as I was concerned, that meant chopping out the second to last bed cross member the width of the tank. I ended up getting a custom built alum. job from no limit eng.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|