|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
08-23-2003, 01:32 PM
|
#1 |
|
Got big-block?
 
Join Date: Jul 2000
Location: Austin, Texas
Posts: 2,453
|
anybody else in DFW go to the Garland swapmeet today...saw a few truck deals
Quite a few project trucks for sale. Lots of fenders and doors. 68 'Burb with barn doors, no motor or trans for sale. A/C units, big block p/s pump set-ups, some NOS trim, etc.
Too bad I didn't need any of that stuff (well, I need a cherry 67 pass fender, but didn't see one). Did pick up some engine stuff I need. The swapmeet's at Audubon Park in Garland. Take exit 9A off 635 and go east on Oats Dr. for about a mile and look for the signs on your right. SC |
|
|
|
08-23-2003, 02:16 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,031
|
Damn.... right down the street & I didn't even know about it. I'll go by there asap.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
