![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Oct 2006
Location: Arizona
Posts: 835
|
stepside bed mounting pads
Hey Everyone
Can someone tell me how thick the rubber bed mounting pads are? |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Nov 2003
Location: Alexandria, VA
Posts: 1,534
|
Re: stepside bed mounting pads
This may sound a bit backwoods, but just get an old inner tube and cut some squares about 3X3 inches and cut a hole in them for the bolt to pass through. Works like a charm...
__________________
'72 GMC SWB C1500 Custom, frame-off in progress. 383 SBC, 9:1CR, Comp Cams XE262H, Scat internal balanced crank, Eagle SIR 6" rods, Keith Black dish pistons, Dart Iron Eagle 72/180 heads, Weiand Stealth intake, Stewart stage I water pump, Holley 4bbl vac sec, TH350 with B&M Shift Improver Kit. 12 bolt positraction. ![]() ![]() ![]() |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2006
Location: Arizona
Posts: 835
|
Re: stepside bed mounting pads
|
![]() |
![]() |
![]() |
#4 |
Senior Member
![]() Join Date: Sep 2000
Location: Agency IA.
Posts: 1,841
|
Re: stepside bed mounting pads
I used an old slick
__________________
72 Chevy short step side with 454 air and tilt. 72 nova project car 63 chevy II drag car Agency Iowa |
![]() |
![]() |
![]() |
Bookmarks |
|
|