|
|
|
03-26-2017, 10:14 PM
|
#1 |
|
Registered User
Join Date: Jun 2016
Location: Davisburg, Michigan
Posts: 54
|
TH350 question
Hey guys...I am looking to put a th350 in place of the 3 speed manual and I need a little help figuring out what parts fit. Hoping I can draw on some expertise in here.
Engine is a 250 inline 6. I know I can use a standard SBC starter, but I am confused about the flexplate. Anyone done this swap that can offer some helpful hints? |
|
|
|
03-27-2017, 09:53 AM
|
#2 |
|
Registered User
Join Date: Oct 2015
Location: Williamston, Mi
Posts: 884
|
Re: TH350 question
I'm getting ready to pull the 250 with 3 speed auto out of my truck, going to replace with a 292 and 200-4R. Also have plans to pull the steering column and replace with a tilt column. Sounds like everything you may need but not sure where you are located.
|
|
|
|
|
03-27-2017, 10:15 AM
|
#3 |
|
Registered User
 Join Date: Jul 2009
Location: huntington beach ca
Posts: 341
|
Re: TH350 question
i just did this sat you need a 153 tooth flex plate at first i had a 168 tooth it was to big and the starter would not even bolt to the block so go with a 153 and your set
|
|
|
|
|
03-27-2017, 06:43 PM
|
#4 |
|
Registered User
Join Date: Nov 2006
Location: KINGSPORT,TN.
Posts: 3,035
|
Re: TH350 question
I like 3 on the tree , trouble free after almost a million miles. a th350 is good but not this good
__________________
I BELIEVE IN JOHN 3:16 |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
