|
|
|
12-05-2011, 12:19 AM
|
#1 |
|
Registered User
Join Date: Jun 2007
Location: Houston, TX
Posts: 230
|
mig to weld on frame
I need to weld my c-notch to my frame before I paint it. My question is, can I weld this with my northern tool 135 amp MIG welder, I have welded up to 1/4 inch plate with this, but don't know if it will be strong enough for a frame, I was also thinking of bolt it down also.. your opinions will be appreciated
I posted this thread on paint and body but I think I should of post here Posted via Mobile Device
__________________
81 chevy stepside 6.0/t56 swap in progress....  81 chevy silverado k5 2wd 350 tpi and 700r4.. SOLD 07 chevy colorado "work truck" SOLD 02 chevy silverado z71 off road package |
|
|
|
12-05-2011, 01:33 AM
|
#2 |
|
Laid Lo
Join Date: Aug 2008
Location: Oceanside CA
Posts: 277
|
Re: mig to weld on frame
I'll be the first to use a 110v welder for all sorts of stuff. Preheating, flux core wire and beveling can all help in getting the most out of them.
My Lincoln 145 is a handy little unit but only in an emergency would I weld a frame with it.
__________________
Semper Fi, Jeff  '72 C10 - lays frame '07 Sand Rail - ecotec powered '05 2500HD - tows stuff '67 VW Bug - gas saver '01 Jeep TJ - rock crawler |
|
|
|
|
12-05-2011, 01:51 AM
|
#3 |
|
Registered User
Join Date: Feb 2009
Location: slurrey, bc.
Posts: 1,134
|
Re: mig to weld on frame
yeah lots of preheat.... and run it with flux and it should be able to do it..
__________________
-'73 c/10 - Low with Go - will be complete... probably never. -'90 2wd Blazer - well... soon enough anyways. -'84 SWB - the daily gas guzzler. |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
