|
|
|
05-08-2012, 07:58 PM
|
#1 |
|
Senior Member
 
Join Date: Dec 2011
Location: Laurel, Mt.
Posts: 522
|
z-bar removal tricks?
Hey guys. Does anyone out there have any advice for removing a z-bar on a 71 k10 with a 350? I can't seem to get it to clear the bracket on the frame and I didn't want to break anything. Thanks
__________________
1972 Cheyenne Super 10 SWB,bucket seats,dealer cruise,tilt,tac,a/c,shoulder belts, 350/350 1971 K-10 Custom Deluxe 1971 K-10 Custom |
|
|
|
05-08-2012, 08:02 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: z-bar removal tricks?
Do you have the nut off of the stud and the stud turned so it will slide out of the slot? (There are two flats on the stud which when aligned with the slot, will allow the stud to slide out).
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
05-08-2012, 08:18 PM
|
#3 |
|
Senior Member
Join Date: Dec 2011
Location: Laurel, Mt.
Posts: 522
|
Re: z-bar removal tricks?
yes I did make it that far, but I can only get it to where the stud almost clears. I wasn't sure if it was ok to pry it up with a big screw driver or if that was a big no-no.
__________________
1972 Cheyenne Super 10 SWB,bucket seats,dealer cruise,tilt,tac,a/c,shoulder belts, 350/350 1971 K-10 Custom Deluxe 1971 K-10 Custom |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
