Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
04-17-2002, 08:14 AM | #1 |
love my truck
Join Date: May 2001
Location: aylmer QC
Posts: 648
|
edelbrock carb 1406 ajustment questions
I just started my truck after instaling edelbrock cam, intake, carb. this was at 2:30 am so I was in a rush. I did not hook up the choke yet. When I press the gaz pedal it stalls, I have to rev it by the carb thigny. Also the top part thigny closes when i give it gaz fom inside the tuck then stals then wont start. I have to go to the carb an open the top thigny then it will start. Is it cause I dont have the choke hooked up? Also where do youwire up your choke? Can you hook it up to the fuse box. Im assuming to a fuse terminal key on power on key off power off.
|
04-17-2002, 08:50 AM | #2 |
Registered User
Join Date: Aug 2001
Location: rock island,il,usa
Posts: 5,382
|
you should be able to hook the wire to ign unfused in the fuse box. As far as any adjustments,go to edelbrock site under carbs,& you should find all the tuning info that you need.... http://www.edelbrock.com/
__________________
http://community.webshots.com/user/hotrodhorn |
Bookmarks |
|
|