|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
06-28-2003, 01:23 AM
|
#1 |
|
Registered User
Join Date: Jun 2003
Location: spokane wa
Posts: 2,189
|
What size rims and tires??
I know this has probably been asked a butload of times on this site..I have a '72 Super Cheyenne 3/4 ton 8 lugger, stock height..
I would like to put jus 16" or 16.5" rims with wide tires on it.. What would be a good width of rim and off set it would need so the tires wouldn't rub???? This site is the best around..Thanks 
__________________
Support The Board Last edited by drink2mny; 06-28-2003 at 01:32 AM. |
|
|
|
06-28-2003, 11:38 AM
|
#2 |
|
20' Daredevil (Ret)
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,698
|
Mine has 16.5x9.75 rims, and 33-12.50 tires. However, I did notch the front of the inner fenders to prevent rubbing at full lock. Since then I put 2" lift springs on front, so I'm not sure if the notches would still be needed. 'Course, they are still there!
 I would like my next rims to be 16x8 with 33" tall tires (I don't recall the size but BFG has one with about 8" or so tread width). I think that would be perfect for The Beast! 
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay Last edited by Stocker; 06-28-2003 at 04:19 PM. |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
