|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
09-21-2010, 08:19 PM
|
#1 |
|
Registered User
Join Date: May 2009
Location: cheyenne wyoming
Posts: 68
|
tilt steering thread ?
does anyone know if there is a thread on here showing how to change the intermediate shaft in tilt columns ? (van column for use in 67 pickup) thanks
|
|
|
|
09-21-2010, 10:24 PM
|
#2 |
|
Registered User
Join Date: Jul 2010
Location: Vista Ca.
Posts: 2,405
|
Re: tilt steering thread ?
There are two plastic/nylon? pins that keep the shaft from sliding that you will need to drive out to change the shaft. There are two ways to go about this, you can drill them or melt them either way you might need to give a couple taps with a rubber mallet to get the shaft to slide. It's really very easy.
|
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
