1972 front hub swap

[ckhdJr.]

Good morning everyone, I was just curious if anybody knew if a 1997 c1500 front hub/spindle would fit onto a 1972 c10 hub? I'm trying to put abs onto my 72.

-Ckhdjr.

[dirtyjim]

it can be done but so far I don't think anyone has been able to get camber close enough to align it without shortening the lower control arms or moving them in. you have to use 3/4 ton lower control arms for the lower ball joints to fit or weld in a larger ball joint sleeve. there was a write-up on using those spindles for a 6 lug disk brake swap using light duty 3/4 ton 6 lug rotors in the suspension section

[ckhdJr.]

Originally Posted by dirtyjim

it can be done but so far I don't think anyone has been able to get camber close enough to align it without shortening the lower control arms or moving them in. you have to use 3/4 ton lower control arms for the lower ball joints to fit or weld in a larger ball joint sleeve. there was a write-up on using those spindles for a 6 lug disk brake swap using light duty 3/4 ton 6 lug rotors in the suspension section

Thank you very much, I appreciate it.

-Ckhdjr.

[jocko]

Originally Posted by ckhdJr.

I'm trying to put abs onto my 72. -Ckhdjr.

Now THAT'S something you don't normally read in someone's very first post Welcome to the forum!