![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Blaze-Air
Join Date: Nov 2008
Location: Virginia
Posts: 1,117
|
Wheel stud replacement
I must have nicked a wheel stud on the rear during my build. I've never replaced one. How is it done?
|
![]() |
![]() |
![]() |
#2 |
Watch out for your cornhole !
![]() Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Re: Wheel stud replacement
You just hammer the old one out.
To install the new one, you can insert it from the back, install a stack of flat washers on the front, and turn a lug nut around backwards and use an impact to pull it in. I have done it many times that way, but the proper way is to use a shop press to press it in place. I bought a cheap Chinese press last year and will never go back. It's invaluable for stuff like this.
__________________
I'm on the Instagram- @Gearhead_Kevin Last edited by Tx Firefighter; 05-22-2009 at 09:35 AM. |
![]() |
![]() |
![]() |
#3 | |
Blaze-Air
Join Date: Nov 2008
Location: Virginia
Posts: 1,117
|
Re: Wheel stud replacement
Quote:
|
|
![]() |
![]() |
![]() |
Bookmarks |
|
|